ABB i-bus KNX SUG/U 1.1, Product Manual

Page: 13 / 56

ABB i-bus
®
KNX
Device technology
SUG/U 1.1 | 2CDC508171D0201 11
2.4 Mounting and installation
The device is suitable for installation in a flush-mounted or wall-mounted box.
The installation position can be selected as required.
The connection to the bus is implemented using the supplied bus connection terminal. The terminal
assignment is located on the housing.
The device is ready for operation after connection to the bus voltage.
The device must be accessible for operation, testing, visual inspection, maintenance and repair in
compliance with DIN VDE 0100-520.
Instructions for installing the supplied infrared cable are provided in the installation and operating manual.
Commissioning requirement
In order to commission the device, a PC with ETS, as well as a connection to the ABB i-bus
®
,
e.g. via a KNX interface, is required.
The device is ready for operation after the bus voltage is applied. No auxiliary voltage is required.
Important
The maximum permissible current of a KNX line must not be exceeded.
During planning and installation ensure that the KNX line is correctly dimensioned.
The device features a maximum current consumption of 12 mA (Fan-In 1).
Mounting and commissioning may only be carried out by electrical specialists. The applicable standards,
directives, regulations and specifications for the country in question must be observed when planning and
setting up electrical installations and security systems for intrusion and fire detection.
•
Protect the device from damp, dirt and damage during transport, storage and operation.
•
Only operate the device within the specified technical data!
•
The IR cable must be installed at least 6 mm away from 230 V power sources.
•
The IR cable must not be kinked or strained.