ABB CPS3200U, Product Manual

Page: 42 / 64

Page 42
© 2021 ABB. All rights reserved.
Step Action
Attach signal wiring to the controller at connector P6. The Ethernet connection to the local network is made
through the P6 RJ45 connector. Of the two RJ45s on the left side of the controller, P6 is the one more toward the
front labeled: P6 10/100 Base
- T. Plug the local network cable into P6. As shown here:
7.
To check the network connection, use the controller display to determine what IP address has been assigned to
the QS941 controller. Press the square key, , on the upper right hand corner of the keypad to display the menu.
8. Press the down arrow key, , 2 times to scroll down to the “ Status ” item on the menu
9. Press the right arrow, , to advance to the “ Status ” menu
10.
Press the down arrow key, , 8 times to scroll down to the “ Network Settings ” item and select by pressing the right
arrow key.
11. Press the right arrow, , to advance to the “ Network Settings ” menu
12. Press the right arrow, , to select Port 1. The P6 connector is Port 1.
13. Read and record the network address for Port 1
When an IP address is listed connection to the server is confirmed