ControlMaster CM10, CM30 and CM50
Universal process controllers,
1
/
8
,
1
/
4
and
1
/
2
DIN
Appendix A – Digital and Analog Sources
116
IM/CM/S–EN Rev. R
Appendix A – Digital and Analog Sources
A.1 Digital Sources
Note.
Numbers in brackets indicate additional parameters, for example, 'Alarm 1 (8) Ack. State indicates that 8
Alarm Ack.
State
parameters are available.
Source Name
Description [Comment]
Alarm 1 (8) Ack. State
Acknowledged alarm = 0
Unacknowledged alarm = 1
Alarm 1 (8) State
Alarm State
Anlg IP 1 (4) Fail
Analog input failure (active when the signal
detected at the analog input is outside the
fault detect level specified during
configuration).
AO1 (2) Loop Break
Analog output
Delay Timer 1 (2)
Delay timer state
IP 1 (4) Digital State
Input 1 (4) digital state
Linearizer 1 (2) Fail
Custom linearizer failure
Logic Equation 1 (8)
Logic equation result
Loop 1 SP Mode
Setpoint mode selected
0 = Local, 1 = Remote
Loop 1 Auto Mode
Automatic control mode
Loop 1 Close Relay
Motorized valve close relay state
Loop 1 LSP 1 (4) State
Local setpoint state
1 = setpoint selected
Loop 1 Manual Mode
Manual control mode
1 = manual
Loop 1 Open Relay
Motorized valve open relay state
Loop 1 TP OP1
Time proportioning output
Loop 1 Valve State
Motorized valve state
Loop 1 Valve Stuck
Motorized valve stuck state
Source Name
Description [Comment]
