- 19 -
008CC3
4 - Connect and configure the CDD
WLess enabled
NO >
E
thernet connection to the internet
WLess connectivity is enabled by default and will need to be disabled before connecting the Ethernet cable
using the following procedure:
•
Press any button on the CDD from the GENERAL INFORMATION display to enter the BASIC menus.
•
Scroll to
WLess Enabled
and press ENTER
•
Use the UP and DOWN keys to change to NO and press ENTER.
Once the wireless is disabled the CHANGE SETTINGS menu will be used to modify the
Network
settings.
•
Press and hold the UP and DOWN buttons on the CDD display at the same time until the
Set Password
screen is displayed.
•
Using the UP or DOWN buttons, enter the password of 0010 by scrolling the
list of characters.
• Press ENTER to confirm each character selected; press ESC to cancel the last
character input.
•
When the password has been entered, scroll to the CHANGE SETTINGS
menu and press ENTER.
•
Scroll to
Network
and press ENTER to select.
•
Scroll to select
Select Network, WLess
and press ENTER.
•
Scroll to
Ethernet
and press ENTER to select.
•
The CDD will automatically restart to reset the connection settings.
Connect the Ethernet cable if not already connected. Two possibilities for cabled
connection of the CDD to the computer are shown below.
The Ethernet port is located on the lower side of the CDD.
For either connection, be careful not to put the Ethernet cable in the RJ45 connector
for RS-485 serial communication.
1.
Through a router using an Ethernet cable
This type of connection can be used both during configuration of the system to access the CDD internal
configuration pages (local web server) and for data transmission to the web portal in order to monitor the
system.
CDD
Ethernet cable
Router / Switch
Set Password
XXXX
Change
Settings >
Network >
WLess >
Select Network
Ethernet >
Select Network