ABB AWIN GW120, User Manual

Page: 23 / 76

BAS IC FEATU RES OF AWIN GW12 0 GATEWAY DECLAR ATIO NS AND CERTIFICATES
4JNO0 0030 8 A 19
3.9 Declarations and Certificates
AWIN GW120 holds the following certificates which makes it suitable for installation in haz-
ardous areas. For terms and conditions, refer to the actual certificates. For other certificates
related to regional compliance and declaration of conformity visit www.abb.com.
To comply with FCC, IC and CE RF exposure compliance requirements, the an-
tenna used for this gateway must be installed to provide a separation distance
of at least 20 cm from all persons.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
3.9.1 ATEX Certificate
The gateway is ATEX certified and is approved for the following marking. A copy of the certif-
icate can be found in the document ID 4JNO000323, available at abb.com.
3.9.2 IECEx Certificate
Refer to the AWIN GW120 IECEx certificate for details.
3.9.3 Ordinary Locations
The gateway has been tested and approved for installation in safe areas by UL. The ORDLOC
compliance information is available in UL File E521295, Volume D14 available at ul.com.
3.9.4 Hazardous Locations
The gateway has been tested and approved for installation in hazardous areas in the US and
Canada. The HAZLOC compliance information is available in UL File E196811, Volume D11
available at ul.com
The gateway rating is as follows:
UL, USA Class I, Division 2 Groups ABCD T4
cUL, Canada Class I, Zone 2 Group IIC T4
The US National Electrical Code (NEC) and the Canadian Electrical Code (CEC) permit the use
of marked equipment in the hazardous areas. The US UL and Canadian UL standards are
based on the NEC and CEC.
3.9.5 EU Declaration of Conformity
EU Declaration of conformity can be found in document ID 4JNO000322. This document can
be found at abb.com.