ABB AWIN GW120, User Manual

Page: 30 / 76

MOUNTING THE GATEWAY INSTALLATIO N
26 4JNO0 0030 8 A
Figure 4: Installation showing end clamps
When mounting the gateway onto a standard 35 mm DIN rail, end clamps should be mounted
on both sides of the module(s) to stop the modules from slipping on the DIN rail (see
Figure
4 ).
Modules are installed from left to right on the mounting rail. Install modules to mounting rail
as described in the following steps.
5. Attach the AWIN GW120 to the mounting rail by positioning the keyway at the top of
the module onto the mounting rail (see Figure 5). Then rotate the module inward until
the DIN rail latch locks the module in place on the rail. Next, check that the module is
fixed securely to the rail by lightly pulling outward on the module.
Figure 5: Installing AWIN GW120 on the DIN rail