TRANSPORTATION, STORAGE AND DISPOSAL
PRODUCT
ACS1000W
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS213400 E01
REV.
J
LANG.
en
PAGE
5.5.3. Storage and handling of spare parts
5.6. Disposal of packaging materials and components
Dispose of the packaging materials and the components at the end of the lifetime
of the drive according to local regulations.
NOTICE
Risk of component damage.
Electronic devices (eg, circuit boards, semiconductors) are sensitive to
electrostatic discharge (ESD), which can damage these devices. Observe
the following to maintain spare parts in good condition and to keep the
warranty valid during the warranty period:
–
Apply ESD handling precautions before handling these devices.
–
Check the spare parts immediately after receipt for damage and
report any damage to the shipping company and the ABB
service organization.
–
Keep spare parts in their original packaging
–
Store printed circuit boards in antistatic bags or boxes
–
Storage temperature range: -5 °C – +55 °C
–
Storage place requirements:
•
Free of vibration and shock
•
Protected against dust, sand, vermin and insects
•
Free of corrosive gases, salt or other impurities that could
damage electronic equipment
•
Dry with no condensation
•
Relative air humidity: 5 – 85%
If in doubt whether the maximum allowed humidity is exceeded,
protect the spare parts by an external heater.
–
Do NOT touch a component without wearing a wrist grounding strap.
–
Put the component on a grounded working surface protected against
electrostatic discharges
–
Hold the component only at the edge
