ABB ACQ580-07, Hardware Manual

Page: 160 / 324

Action
Make sure that it is safe to connect voltage. Make sure that:
• cabinet doors are closed
• nobody is working on the drive or circuits that have been wired from outside into the drive
cabinet
• cover of the motor terminal box is on.
Close the main switch-disconnector (Q1).
Setting up the drive parameters, and performing the first start
Setup the drive control program. See Quick start-up guide for ACQ580 drives with pump
control program (3AXD50000048773 [English])
Powering up
Drive with the emergency stop cat. 0 (Q951): Reset the emergency stop relay (A61)
with the emergency stop reset button (S62) on the cabinet door. Otherwise you cannot close
the main contactor.
Drive with the emergency stop cat. 0 (Q963): Reset the emergency stop relay (A61)
with the emergency stop reset button (S62) on the cabinet door. Otherwise you cannot start
the drive because the STO signal circuit is open.
Drives with main contactor (Q2, F250): Close the main contactor by turning the op-
erating switch on the cabinet door from OFF into ON position.
Perform the first start of the drive and motor.
Stop the motor and drive.
Drives with a fieldbus adapter module (optional): Set the fieldbus parameters. Activate the
appropriate assistant in the control program, or see the user’s manual of the fieldbus adapter
module, and the drive firmware manual. Not all control programs include assistants.
Check that the communication works between the drive and the PLC.
On-load checks
Check that the cooling fans rotate freely in the right direction, and the air flows upwards. A
paper sheet set on the intake (door) gratings stays. The fans run noiselessly.
Check that the motor starts. stops and follows the speed reference in right direction when
controlled with the control panel.
Check that the motor starts. stops and follows the speed reference in right direction when
controlled through the customer-specific I/O or fieldbus.
Drives in which the Safe torque off control circuit is connected: Test and validate the operation
of the Safe torque off function. See chapter
The Safe torque off function (page 273) .
Drives with an emergency stop circuit (oQ951 and +Q963): Test and validate the
operation of the emergency-stop circuit. See section
Implementing the emergency stop
function (page 97) .
156 Start-up