ABB 266 HART Series, Operating Instruction

Page: 38 / 80

38 OI/266/HART-EN Rev. D | 2600T Series Pressure transmitters
266 Models - HART
This menu allows the parameterization of the process alarm. The menu driven
structure will guide you through the choice of the fail safe functions such as
the saturation limits and the fail level (upscale or downscale).
This menu allows the local calibration of the instrument. The menu driven
structure will guide you through the choice of pressure sensor trimming (low
or high), the output setting (set to 4 or 20 mA) and at the end you can reset
these parameters (to factory sensor trimming, to user sensor trimming or to
factory output trimming).
This menu allows the set-up of the on-board totalizer. The menu driven structure
will guide you through the selection of the totalizer input parameters (run/stop
totalization), the choice of the totalization mode (normal, batch, forward/reverse,
f reverse and forward – reverse), the configuration (unit and conversion
factor of totalizer 1 and 2). Furthermore, it is possible to set up the values of the
batch totalizer (count direction, present value and reload). User will be able to
add/change/delete the password as well as to reset all totalizers.
This menu allows you to monitor diagnostics messages related to pressure
variable, output current, output percentage, scaled output, static and sensor
pressure.
The menu driven structure will also guide you through the loop test (set 4 and
20 mA and set the output value).
This menu gives you all information about the device.
The menu driven structure will show you what is the sensor type, the hardware
and software revisions, the high and low sensor limits as well as the minimum
applicable span.
The last section of this structured and driven menu gives you the possibility of
changing the communication tag and the MULTI-DROP mode with HART
address numbers of the device.