Installation
40
Configuring the slot
1.
Log in to the
Configurator
as a user with administrator rights.
Switch to the
Configurator
’s
Expert
mode to obtain all required dialogues.
2.
Open the
Telephony: Ports: Slots
menu.
Card type
a/b Trunk
is displayed in the
inserted
column for the selected
Slot
if
the card is inserted into the slot.
Note
If the card type is not displayed, the interface card has not been detected. Ensure
that the interface card has been installed correctly.
3.
Click on the desired entry in the
Slot
table.
4.
Select card type
a/b Trunk
from the
configured
list.
5.
Click on the
Apply
button.
Creating a new bundle
After you have configured the slot, the trunk lines need to be configured. Start by cre-
ating a new bundle:
1.
Open the
Telephony: Trunks: Bundle
menu.
On the status page, the list of previously configured bundles is displayed.
2.
Click on the
New
button.
3.
Select the
Analog trunk
entry from the
Access type
list and enter a bundle name
in the
Name
field.
4.
Fill in the other fields of the dialogue. The settings in the
Max. time between
ringing pulses
,
Time to ready line
and
Time to ready dial out
fields are man-
datory.
5.
Click on the
Apply
button.
Assigning a route
In order to allow the analogue lines of the M100-AT4 Interface Card to be used for out-
going calls, the bundle needs to be assigned to a route:
Summary of Contents for OpenCom 100 series
