Aastra Dialog 5446 IP Premium, User Manual

Page: 23 / 87

Starting the Phone
3 Starting the Phone
3.1 Starting and Logging On
All the system settings for your IP phone must be set by the system
administrator before you can use the phone.
Depending on the settings in your network and telephone system, the start up
procedure may differ from phone to phone. Check the display on your phone
and read the relevant sections in this chapter to continue with the startup
procedure.
When the phone is connected to the network, your phone automatically initiates
the startup procedure when connected to the mains.
After a power failure the phone restarts automatically.
Note: During power-up, the phone display is black for a little while.
LAN access control
Your telephone might require a network authentication to gain access to the
network. You then have to enter a valid user name and password.
Note: The user identity and password used for the network authentication
are not the same user identity and password you use to log on to the
telephony system. Contact the system administrator to obtain a new
password or change an old password.
1. On the main page, tap the Log on with field and enter your user name
(typically the extension number).
If you need to edit the input, tap the Erase button.
2. Tap the Enter password field and enter your password. If you need to
edit the input, tap the Erase button.
Note: You can enter the password from the keypad on the phone, or from
the soft keyboard in the display.
3. Tap the Log on button to continue the startup procedure.
If your user name and password are not accepted, an error message is
displayed. Contact your system administrator.
Continued startup procedure
17
8/1553-DBC 446 01 Uen B3 2008-09-10