AAQ AutoLift AL-3000AG, Installation Manual & Operation Instructions

Page: 33 / 37

3000kg
Scissor Hoist
OPERATING INSTRUCTIONS
The hoist should only be operated by personnel that have been
thoroughly trained in operation and maintenance of the hoist .
1. Drive the vehicle evenly over the scissor platform and
apply the park brake.
2. Install the four rubber lifting blocks to the underside of
the jacking points of the hoist.
3. Make sure that all personnel are clear and there are no
obstructions around the hoist .
TO RAISE THE HOIST
1. Press the “UP” button on the control panel to
approximately 500mm above the floor.
2. Check that the vehicle is evenly balanced on the hoist .
3. Continue raising the hoist to the desired working height
checking for any obstructions.
4. Once the hoist has reached the desired working height
press the lock button until the vehicle has rested on the
locks
Important: a visual check is to be made for correct
engagement of the locks prior to going under the hoist .
TO LOWER THE HOIST
1. Check for any obstructions under the hoist prior to
lowering the hoist .
2. Press the “DOWN” button on the control panel until the
locks are clear
Please note: the hoist will raise approximately 100mm
and then will descend automatically.
3. Once the hoist has reached its lowest position, remove
the rubber supporting blocks.
4. Turn the power switch to the off position on the control
panel.
Design Code: AS1418.9 -1996
MODEL:
AL-3000AG
SERIAL NO.: APPROVALS:
WAH2160