AAQ AutoLift AL-3000AG, Installation Manual & Operation Instructions

Page: 14 / 37

Installation, Operation and Parts Manual
14
AL- 3000AG (FL-8801)
4.4 Operation instructions
Raise the
hoist
1.
Make sure that you have read and understood the operation manual before operation.
2.
Drive and park the vehicle midway between two platforms.
3.
Place the four rubber pads under the prop-points of the vehicle and ensure car’s gravity have fallen on the rubber pads.
4.
Press the UP button on the control box until rubber pads have touched the prop-points of vehicle.
5.
Keep on pressing the UP button to
hoist
the vehicle a bit higher from the ground and check again if the vehicle is in a safe position.
6.
Having raised the vehicle to the required height, operators must press the “Emergency stop” button until the power indicator is off
and check again the stability of the vehicle before performing maintenance or repair work,
Lower the
hoist
1.
Switch on.
2.
Press the DOWN I button to lower the
hoist
. It will stop lowering when clearance between the platforms and the ground
reached to 500mm.
3.
Press DOWN II button to continue lowering the platforms. Alarming buzz will be heard unless you stop pressing DOWN II.
4.
Drive the vehicle away
4.5 Emergency lowering in case of no power
Pneumatic lock is not engaged
1. Pull up the safety teeth with steel rope to release the safety lock.