AAQ AutoLift AL-10000T, Installation Manual & Operation Instructions

Page: 11 / 39

5. The Columns and Cross Beams will now be in position
and spaced properly for the Runways.
6. Install the Column TOP CAPS using the M1 2 x 2 Hex
Bolts, nuts & washers. Install the nut on each Safety Lad-
der until 12mm of threads are exposed and the Ladder is
raised at least 12mm off of the base of the Column.
NOTE: Raise the Ladder at least 12mm off of the base of
the Column or damage to the hoist will occur. Be sure to
position the cable hole INWARD. (See Fig. 4.6 - 4.7)
1. Before proceeding it will be necessary to first raise
the Cross Beams off the ground to facilitate
Cable routing and final assembl y.
2. Manually raise the Cross Beams until the Primary
Safety Locks engage and rest on the lock position second
down from the top of the Ladder or approximately 700mm
off the ground. It is important that the SLACK SAFETY
LOCK IS CLEARED. The Slack Safety Lock must never
rest on the Safety Ladder. To prevent this, manually hold
the Slack Safety in the disengaged position while
lowering the cross beams ends. (See Fig. 5 .1)
3. The Columns and Cross Beams will now be in
po sition and spaced properly for the Runways. Be very
careful not to disturb the Columns and Cross Beams
at this time as they may tip over causing personal
injury or harm. (See Fig. 5.2)
DANGER!
Be careful not to disturb the Columns and Cross beam
as they may tip over causing personal injury or harm.
IMPORTANT NOTE !
It is important that the SLACK SAFETY LOCK IS
CLEARED. The Slack Safety Lock must never rest on
the Safety Ladder.
Fig 4.7
Fig 5.1
Fig 5.2
Fig 4.6
Slack wire rope lock engaged
Slack wire rope lock disengaged
700mm
4.5 Raising the Crossbeam
10