Anchoring the posts
The AutoLift AL-10000T is a portable hoist made to function without being anchored to the floor. The hoist however is
designed to be anchored to the floor and we
STRONGLY
recommend when lifting a vehicle to anchor the hoist to the floor
using the provided anchor bolts. Anchoring the hoist will make the hoist more stable, but the hoist will not be portable until
the anchors are removed. Your will need a rotary hammer drill with a 19mm carbide masonry drill bit (most rental outlets
have them for rent.)
Your concrete floor must be a least 125mm thick and a minimum of 25MPA. Drill through 16 holes into the
concrete, drilling all the way through the floor. Install the nut and flat washer on the Anchor bolt before putting
them into the holes. Be careful not to move the posts when drilling. One way to avoid this is to drill the holes
and place the bolts in one at a time after the holes are drilled. Re
-
check the level of each column and place
shims around each anchor and whenever they’re needed. If 12mm or more shim is required, either refinish
concrete or use steel plates and extra long anchor bolts. Tighten the anchor bolts and recheck for level and
plum. Hammer the anchor bolts all the way down. Tighten anchor bolts using a toque wrench to 150 ft. /lbs
(203 N.m)
(DO NOT USE AN IMPACT GUN WHEN TIGHTENING THE ANCHOR BOLTS)
Note: 125mm of embedment is the minimum requirement for reinforced concrete.
Recheck the level of the posts. If the posts are off level at this point, loosen the anchors and use a pry bar to tilt
the posts and shim as needed. Retighten and check again. When satisfied as to level, tighten all the anchor
bolts.
THE PROPER OPERATION OF THE HOIST REQUIRES THAT ANY TIME YOU RAISE A VEHICLE
YOU MUST LOWER THE HOIST ONTO THE SAFETY LOCKS.
This is done by raising the vehicle to the desired height and lowering the hoist by pressing the release valve
handle until the hoist stops on the next available lock
(check for correct engagement on all locks prior to use)
Note: the power unit is not made to hold the load and may bleed down the locks .
4.4 Foundation Dimensions / Specifications
8
Summary of Contents for AutoLift AL-10000T
