Operator Interfaces SD
APPENDIX A - SAVE, LOAD, COPY SETPOINTS
15
Save & Copy Setpoints - Stand-Alone
Mode
The instructions for Stand-Alone Mode are exactly the same as
Network Mode, except that there is no need to enter a Loop number
in the Unit ID number fi eld and in the
Copy Setpoints Screen
, enter
a zero in the ‘From Loop’ fi eld.
Restore Setpoints - Network or
Stand-Alone Mode
The Restore Setpoints feature is used to reload a saved setpoints fi le
from one controller back to itself. This could be useful if setpoints
or confi gurations were changed and need to be reset.
You can perform this function on a networked system; however, the
Modular Service Tool needs to be directly connected to the controller
you wish to restore previously saved setpoints to.
From the screen shown below, scroll down to the ‘Save/Copy/Re-
store’ option shown above and
press
<ENTER>
.
Change Setpoints
Configure Unit
Save/Copy/Restore
This will take you to the
Save Setpoints Screen
shown below.
Save Setpoints
Press Enter To Save
Press
<
>
four times to access the
Restore Setpoints Screen
shown
below.
Restore Setpoints
Press Enter to Load
Press
<ENTER>
. This will reload the setpoints from the saved fi le.
You will receive confi rmation that the setpoints were loaded suc-
cessfully.
Restoring Previously Saved Setpoints
