Operator Interface SD
INITIALIZATION
11
Unit Alarm Search and Override Search
Alarm Screen
NO ALARMS DETECTED
To check controllers individually for alarms, use the
<ALARMS>
button on the Main Display.
Unit Alarm Search
The System Manager can be used to search for all active alarms one
controller at a time.
Press
<ALARMS>
. The
Unit Selection Screen
below will be displayed.
Enter Unit Address
Then Press Enter
Selected Unit#: XXXX
Enter the Unit ID of the controller you want to confi gure and
press
<ENTER>
. Once communication is established, the words “Press
Down” will appear at the bottom of the screen.
NOTE:
If “Press Down” does not appear at the bottom of the
screen, communication with the controller has not
been established.
The following screen will appear. The System Manager will search
for any active alarms on the unit and one of the following screens
will appear:
CONTROLLER V.XXX
NO ALARMS
CONTROLLER V.XXX
ALARMS PRESENT
SCROLL DOWN TO VIEW
Press
<
>
to scroll through all the alarms for the controller that the
Modular Service Tool is connected to.
To clear any alarms that are found, you must fi x the problem indicated
in the alarm. Once the problem is fi xed, the alarm will clear from
the screen the next time the unit is polled.
System Manager Override Search
NOTE:
In order for the Override Search to work, a Loop
Search must be performed fi rst. See
page 10
for de-
tails.
When a space sensor with override option is used with any VAV/Zone
Controller or Unit Controller, the System Manager can determine
and report any controllers that are currently operating in an override
condition. This function requires that a MiniLink PD is installed on
each loop where the controllers may be located. The MiniLink PD
must be confi gured to allow for “Alarm Polling” for each controller
that Override Polling Enabled is desired for this function to work. See
the MiniLink PD programming section on
page 17
of this manual
for setting information.
To access the
Space Sensor Overrides Screen
,
press
<OVERRIDES>
,
The following screen will appear.
Overrides Screen
SEARCHING!
After the System Manager completes its search, it will list the fi rst
unit on the system that is currently in the override mode.
Press
the
<
>
button to scroll through all units that are in the Override Mode.
Overrides Screen
Loop = 1 Unit = 59
OVERRIDE FOUND
