Zone
Zone
INITIALIZATION
Operator Interface SD
12
Week Schedules
From the
Unit Schedule Menu
, select Week Schedules. The following
two screens will appear in order:
Event #1
Schd
Sunday Event #1
Start Time..: XXXX
Stop Time...: XXXX
Event #2
Schd
Sunday Event #2
Start Time..: XXXX
Stop Time...: XXXX
If you are using the internal scheduling capability of the Controller,
set the schedule hours and holiday periods from the menu shown
above. You can also force the unit to operate continuously in occupied
or unoccupied mode by selecting the Schedule Override menu item
and entering the desired command.
If you are using an external contact closure to signal the occupied
mode, you must access the
Week Schedule Screens
and set all start
and stop times to zero to prevent the internal schedule from turning
the equipment on when you don’t want it to operate.
The screens will step through the
Start Time
and then the
Stop Time
for each day of the week. You can quit at any point in the process by
pressing
<ESC>
. There are two Start/Stop events available per day,
so the screen will show which event is being programmed. If you
need only one event, keep Event #2’s times set at ZERO.
All times are in 24-hour military format, so 5:00 PM would be
entered as 1700.
If both the Start and Stop Times are ZERO, the schedule is in a
continuous OFF mode. (
Use for Remote Signal Contact.
)
Scheduling
You can access the Controller Scheduling Screens by
pressing
<SCHEDULES>
. The screen below will appear because Scheduling
requires passcode clearance. A Level 1 or 2 passcode can change
schedules.
THIS ACTION REQUIRES
PASSCODE CLEARANCE
Enter Passcode: XXXX
If the correct passcode was entered, the
Unit Selection Screen
will
be displayed.
Enter Unit Address
Then Press Enter
Selected Unit#: XXXX
Enter the Unit ID of the controller you want to confi gure and
press
<ENTER>
. Once communication is established, the words “Press
Down” will appear at the bottom of the screen.
NOTE:
If “Press Down” does not appear at the bottom of the
screen, communication with the controller has not
been established.
The
Unit Schedule Menu
will be displayed.
Schedule Menu
Schedule Override
Week Schedules
Holiday Schedules
Press
the
<
>
button until the cursor is on the desired option and
then
press
<ENTER>
.
Schedules and Holidays
