-15-
mated capacity and battery voltage. If there was not
possible to estimate capacity, the alarm message is
sent to this screen zone (see section 4).
Battery capacity
– measured in ampere-hours.
Battery voltage
– measured in volts
.
If the noise
level is rather high, the “noise” message arrives in this
screen zone.
Right part of the screen
(the zone of inversion)
contains additional information.
Fig.2 Screen under “save by default” mode
Coefficient
– the multiplier (calibration coeffi-
cient) used to estimate capacity (see section 6.3).
Current group
– the group to which just re-
ceived test result was saved (memory organisation is
described in section 5).
Number inside group
– the number of just re-
ceived test result inside current group.
-16-
Memory cells free
– total number of test results
that can be saved in memory (not more then 200).
Time
– there is time indication at the most right
part of the screen (not shown in fig.2).
3.3.2. Screen under “save by command” mode
Figure 3 shows screen view for the case when
“save by command” mode is chosen.
When this mode is used, just received test result
is not saved. There is no battery name (group and num-
ber inside group) on the screen. The function of the
lower button is changed.
Save result
– after pressing the lower button
you will have 3 possibilities:
Fig. 3 Screen under “save by command” mode
a) to save the just made estimation to the
memory (group name and the battery number is
shown);
b) to return to the last screen;
c) to initiate the test repetition.
Save result
Coefficient
Menu
enter
Delete result
Battery
voltage
Number
inside group
Memory
cells free
Current
group
Battery
capacity