A&D FZ-1200CT, Instruction Manual

Page: 12 / 84

10
4. DISPLAY SYMBOLS AND KEY OPERATION
Key operation
Key operation affects how the balance functions. The basic key operations are:
“Press and release the key immediately” or “Press the key”
= normal key operation during measurement
“Press and hold the key”
Display symbols
Each key, when pressed or when pressed and held, functions as follows:
Key When pressed When pressed and held
Turns the display on or off. The standby indicator is displayed when the display is
turned off. The weighing mode is enabled when the display is turned on.
This key is available anytime. Pressing the key during operation will interrupt the
operation and turn the display off.
In the weighing mode, turns the minimum
weighing value on or off.
In the counting or percent mode, enters
the sample storing mode. Enters the function table mode.
Refer to “9. FUNCTION TABLE”.
Switches the weighing units stored in the
function table.
Refer to “9-9 Storing Units”. Enters the response adjustment mode.
Cancels the operation when performing
settings. With the FZ-CT
series, enters
the calibration mode using the internal
mass. (One-touch calibration)
Enters the calibration mode using an
external weight.
Outputs the weight data to a printer or
personal computer using the RS-232C
serial interface, depending on the
function table settings.
Confirms the operation when performing
settings.
No function at the factory setting
By changing the function table:
Outputs “Title block” and “End block” for
GLP/GMP compliant report.
(Refer to “10-2 GLP Report”.)
Sets the display to zero.