BM series
73
14. Density Measurement
(
Specific gravity
)
The balance is equipped with a density mode. It calculates the density of a solid using the weight
of a sample in air and the weight in liquid. We recommend the use of the AD-1653 Density
Determination Kit.
Notes
The density mode was not selected for use when the balance was shipped from the factory.
To use this mode, change the function table settings to activate the density mode.
Refer to "
5.2. Storing Active Units
".
When the density mode is selected, the response adjustment function cannot be used.
The readability is 0.0001 g while using the density mode.
Formula to obtain the density
The density can be obtained by the following formula.
Where
: Density of a sample
A : Weight value of a sample in air
B : Weight value of a sample in liquid
0
: Density of a liquid
Prior to measurement: Changing the function table
Prior to measurement, change the function table as follows:
1 Selecting the density mode.
The density mode is not available in the factory setting. To use the mode, select it (unit of
Unit
.)
in the function table. Refer to "
5.2. Storing Active Units
". Then, the density mode can be selected as
one of the weighing units by pressing the
MODE
key.
2 Selecting a way to set the density of a liquid.
Select the liquid density input method from the function table below.
Note The following function table is displayed only when the unit of
Unit
is active. The table
of the density function (
d5
fnc
) is displayed after
5if
.
Class Item
and
Parameter
Description
0
Water temperature
d5
fnc
Density function
ldin
Liquid density input
1
Liquid density
Factory setting.
A
=
x
0
A
-
B
Summary of Contents for BM-5
Page 1: ...Analytical Balance BM 5 BM 5D BM 20 BM 22 BM 252 BM 200 BM 300 BM 500 1WMPD4002195E...
Page 8: ...6 BM series...
Page 115: ......
