A&D BM-5, Instruction Manual

Page: 66 / 116

64 BM series
Calibration test report using an external weight
Note Calibration test does not perform adjustment.
If the data memory function is used (except data 0 ), the "Title block" and "End block"
cannot be output.
Key operation
1 Press and hold the
CAL
key to display CC out and release the key.
2
Cal 0
is displayed.
3 To update the target weight value, press the
RANGE
key and proceed to Step 4.
To use the preset target weight value, proceed to Step 5.
4 Specify the target weight value using the following keys.
RANGE
key ..........To select the blinking digit.
RE-ZERO
(
+
)key ....To increase the value of the blinking digit.
MODE
(
-
)key.........To decrease the value of the blinking digit.
PRINT
key............To store the new value.
5 Press the
PRINT
key. The zero point is measured and the weight value is displayed for a few seconds.
6 Place the displayed target weight on the pan. Press the
PRINT
key to measure the weight. The weight
value is displayed for a few seconds.
7 end is displayed. Remove the weight from the pan.
8 If GLP output is used,
glp
is displayed and the calibration test report is output.
9 The balance returns to the weighing mode.
Function
setting " info 1 " Function setting " info 2 "
AD-8121 format General format using the balance built-in clock data
Space, ASCII 20h
<TERM> Terminator, CR , LF or CR
CR Carriage return, ASCII 0Dh
LF Line feed, ASCII 0Ah
Manufacturer
Model
Serial number
ID number
Date
Time
Calibration test type
Zero point value
Target weight value
Target weight
Signature
----------- A - & - D
MODEL ----- BM-300
S/N ----- 01234567
ID ------ LAB-0123
DATE -- 2011/02/20
TIME ---- 12:34:56
CAL.TEST(EXT.)
ACTUAL
------- 0.0000 -- g
---- +200.0002 -- g
TARGET
---- +200.0000 -- g
SIGNATURE
-
- - - - - - - - - - - - - -