51
15.2.8. Checking the serial data
Check the serial input and output. (RS-232C/RS-485)
“
WT,0123456(unit)
”
is output in the stream or manual print mode.
When receiving the
“
R
”
command,
OK
turns on.
Switch between the stream mode (
HI
is
turned on) or manual print mode (
LO
is
turned on).
While this key is pressed, the baud rate of the
setting is displayed.
While this key is pressed, the data bit length,
parity, stop bit and terminator of the setting
are displayed.
Output the data.
Proceed to the selection mode. (Refer to “
”)
15.2.9. Checking the keys
Check the state of each key.
Ones digit (0/1)
Tens digit (0/1)
Hundreds digit (0/1)
Thousands digit (0/1)
ten thousands digit (0/1)
(If you want to proceed to the selection mode,
press this key twice quickly.)
15.2.10. Checking the DZ memory
Display how much space is available in DZ memory as a
percentage.
Proceed to the selection mode. (Refer to “
”)
Selection mode
Press twice
HI OK LO
Set value
display
Output
Selection mode
Selection mode
Summary of Contents for AD-4531B
Page 59: ...Blank...
