@2013 6Harmonics Inc. All Right Reserved
21
Note1: The Software will only allow the user to increase the maximum power
up to the maximum permissible power.
Note2: If manual power control has been implemented, the user should refer
to the section in the document which details the power control procedure to
ensure the link is configured properly.
7.9 gettxpwr command
The “gettxpwr” command will return the current tx power setting in dbm:
GWS Cmd >gettxpwr
CurTxPower: 11.5 dbm
GWS Cmd >
7.10 rfinfo command
The “rfinfo” command will return the current radio configuration:
GWS Cmd >rfinfo
6 Harmonics GWS-1100 - Rev 04
Firmware #601100-410 Generated at: Jul 9 2013 16:25:19.
Radio SNO : 19
TX : DOWN
RX : DOWN
Region : 0
Channel : 41
CurTxPower : 20.0 dbm
MaxTxPower : 20.0 dbm
MinTxPower : -6.5 dbm
RX Gain : 12.0 dbm
Temperature : 38.0 C
GWS Cmd >
7.11 u command
The “u” command will set tx power up 0.5dBm:
GWS Cmd >u
7.12 d command
The “d” command will set tx power up 0.5dBm:
GWS Cmd >d
Note: The “u” and “d” commands are used to perform manual power control
and load balancing to optimize network performance. The can be used to
increase or decrease transmit power during while the node is in service and
carrying traffic.