@2013 6Harmonics Inc. All Right Reserved
18
After changes, save it, then reset.
6.7.3 Radio turn on (For non database application)
The default setting radio is off. To turn on the radio with out database access, in
SSH Shell
Type txresume, the radio will be enabled.
Note: This functionality is only available for units shipped to countries which do not
use a White Space Database. For US customers this capability is not provided.
6.7.4 Check channel number (For non database application)
For non database application, after the radio has been enable, expect the
connection is up at this time. If not, please check if BTS and CPE are configured to
the same channel.
7.0 User Commands
As stated previously, users commands are a set of commands for users to configure the radio and get
information from the radio. The supported commands are listed in table 1 and can be exercised by telnetting to
the node.
Table 1. General User Commands
Commands Description
setchan
Set Channel Number
getchan
Show Channel Number
setagcmode
Set AGC mode
getagcmode
Show AGC mode
rfinfo
Show RF informations
u
Tx power up 0.5dBm
c
Tx power down 0.5 dBm
cu
Tx power up 5 dBm
cd
Tx power down 5dBm
settxpwr
Set Tx Power
gettxpwr
Show current Tx power
monitor
Show Node status
setinstaller
Set installer
getinstaller
Show information about who install the node
getchanlist
Show channel list
getsubchanlist
Show sub channel list
txoff
Turn off Tx
txresume
Resume the Tx
gettxstatus
Show tx status
getrxstatus
Show rx status
setchanlist
Set channel list
setsubchanlist
Set Sub Channel list
setrxgain
Set Rx Gain
getrxgain
Show Rx Gain
