- 6 -
Physical Description
Front Panel
Status LED’s
Each time Video Server starts up, it will perform
power-on-self-test, abbreviated as POST, to
examine every hardware module. As soon as the
administrator plugs in the power connector both
LED’s under the power LED will flash one by one
until the diagnosis is done. If the result is good,
both status LED’s will turn off for a while and
then follows the pattern below. If any module
fails, refer to the Appendix A for the error pattern
and follow the trouble-shooting procedures. If the system still cannot operate normally,
please contact your reseller for technical service.
Network Interface Condition
LED1 (Heartbeat) LED2 (Status)
before IP installed
OFF
OFF
after IP installed
Blink
OFF
Ethernet
during camera control Blink
Blink
after POST
Blink
ON
PPP with modem
during camera control Blink
Blink
before connected
ON
ON
after connected
Blink
ON
PPP with null modem
during camera control Blink
Blink
Summary of Contents for IPVS4
Page 1: ......
