3M PROTECTA 3590500, User Instructions

Page: 5 / 68

5
;
Before using this equipment, record the product identification information from the ID label in the ‘Inspection and
Maintenance Log’ at the back of this manual.
Table 1 – Product Specifications
System Specifications:
Anchorage: Anchorage structure requirements vary with the system application and whether it is a certified
anchorage or non-certified anchorage. The anchorage structure must sustain static loads applied in
the directions permitted by the Fall Protection system.
System Application Certified Anchorage Non-Certified Anchorage Defined by
Fall Arrest 2 times maximum
arresting force
5,000 lbf (22.2 kN) OSHA, ANSI
Restraint 2 times foreseeable force
1,000 lbf (4.4 kN) per ANSI
5,000 lbf (22.2 kN) per OSHA
OSHA, ANSI
Rescue 5 times applied load 3,000 lbf (13.3 kN) ANSI
When more than one system is attached to an anchorage, the strengths stated above must be
multiplied by the number of systems attached to the anchorage. See ANSI Z359.2 for more
information.
;
Anchorage must be approved by a Qualified Person.
Service Temperature: -40°F to 130°F (-40°C to 54.4°C)
Standards: Each product model is certified to, or conforms with, the applicable standards and regulations listed
within Figure 1. If none are specified, then all standards and regulations listed on the cover apply.
Component Specifications:
Figure 2
Reference
Component Materials
A Lifeline (see Lifeline Specifications)
B Housing Aluminum
C Bottom Connector (see Connector Specifications)
D Top Connector (see Connector Specifications)
E Swivel Eye Steel
F Energy Absorber Rubber cover with polyester lifeline
G Rotation Handle Steel
H Bracket Stainless steel
--- Drum Aluminum
;
Internal Components: Internal SRD components are made from a combination of Stainless Steel, Steel, and Aluminum.
Connector Specifications:
Figure 1
Reference
Model Number Description Material Gate Opening Gate Strength
C1 2000112 Carabiner Steel 11/16 in. (17 mm) 3,600 lbf (16 kN)
C2 2000175 Swivel self-locking snap hook Zinc-plated steel 3/4 in. (19 mm) 3,600 lbf (16 kN)
C3 2100044 Swivel self-locking snap hook Stainless steel 3/4 in. (19 mm) 3,600 lbf (16 kN)
;
Tensile Strength:
The tensile strength of each of the connectors listed above is 22.2 kN (5,000 lbf).
Lifeline Specifications:
Figure 1
Reference
Description
GS1 7/32 in. (5.56 mm) galvanized steel wire rope
GS2 3/16 in. (4.76 mm) galvanized steel wire rope
SS1 3/16 in. (4.76 mm) stainless steel wire rope
C1 C2 C3