Maintenance
Model
C1025
14
©
3M 2006
When the battery voltage is too low, the headset sounds a short, low-
volume tone at seven-second intervals to alert the operator to install a
fully charged battery. The "battery voltage low tone" continues for two
minutes after which the transceiver pack turns off automatically to
prevent damage to the batteries.
9
Note
When installing a battery, make sure it is fully charged. It is important to
remember that an unused C1025 battery loses five percent of its charge
per week. If a battery has not been used for several weeks, make sure to
charge prior to use.
To replace the battery:
1. Push the battery release to release the battery. See Figure 12.
2. Remove the discharged battery from the transceiver pack.
3. Insert
a
fully charged battery
in the unit. Make sure the battery is
fully inserted (battery release clicks). See Figure 12.
9
Note
The C1025 can operate on one battery or two. Using two batteries doubles the
operating time between charges, and increases operating range.
If two batteries are used, both must be recharged at the same time.
Figure 12. Replacing the Batteries
Transceiver Pack
Replacing the Battery
