Model C1025
System
Setup
©
3M 2006
7
To prepare the Headset System for use, you will need to check the
components for proper assembly and positioning.
1. Peel the clear plastic Tape Pull Tab from the release paper.
2. Hold the Tape Pull Tab so the sticky side is facing up and the hole is
toward the end of the plug as shown.
3. Insert the Type III Headset plug down through the hole in the Tape Pull
Tab as shown.
4. Fold the Tape Pull Tab up around the plug so the sticky sides adhere
together as shown.
5. You now have a Pull Tab to easily remove the headset plug.
To connect the headset to the transceiver pack:
1. Insert the communications plug at the end of the headset cable into the
jack in the bottom of the transceiver pack. See Figure 7.
2. Press the cable into the cable channel on the bottom of the transceiver
pack. See Figure 7.
•
Direct the cable toward the Page button to wear the transceiver pack
on the right hip.
•
Direct the cable toward the Talk Lane 1 button to wear the
transceiver pack on the left hip.
Figure 7. Connecting the Headset Cable to the Transceiver Pack
Introduction
Attaching Tape Pull Tab
to Type III Headset
Connecting the
Headset to the
Transceiver Pack
