3M 6204, User Manual

Page: 140 / 144

1 2 3 4 5 6 7 8 9
Appendix B Appendix B Appendix B Appendix B – – – – Error Handling Error Handling Error Handling Error Handling
128
128 128
128
3M Toll RFID Reader 6204
3M Toll RFID Reader 6204 3M Toll RFID Reader 6204
3M Toll RFID Reader 6204 User’s Guide
User’s Guide User’s Guide
User’s Guide
Warnings Warnings Warnings Warnings Event Event Event Event Description Description Description Description Corrective Action Corrective Action Corrective Action Corrective Action
MDM_OVER_TEMP event.warning.hw The measured temperature is higher than the
warning threshold, but not high enough to cross
fault threshold. None required.
MDM_
POWERMEASURE_
CLIPPED event.warning. radio An error is detected in the power reading
process. None required.
MDM_
PREDISTORTION_
DATA_MISSING event.warning.hw Unable to find valid predistortion calibration data
from the reader flash. None required.
MDM_RC_NO_
AVAILABLE_
FREQUENCIES event.warning. radio The modem is unable to find valid frequencies. None required.
MDM_REFLECTED_
POWER event.warning.
antenna An antenna's return loss is lower than the
warning threshold, but not low enough to cross
the fault threshold. None required.
MODULE_NOT_
INITIALIZED event.warning.sw Indicates a failure in module initialization. None required.
NULL_POINTER event.warning.sw Indicates a failure in the pointer. None required.
READER_RESET_FP
_SWITCH_FACTORY
_ SET_ERROR event.warning.sw Error detected during reset of profile to factory
default when pressing the hardware reset
switch. None required.
READER_RESET_FP
_SWITCH_NETWOR
K_SET_ERROR event.warning.sw Error detected during reset of network to factory
setting when pressing the hardware reset switch. None required.
READER_RESET_FP
_SWITCH_SERIAL_
CONSOLE_SET_
ERROR event.warning.sw Error detected during reset of serial interface to
CLI when pressing the hardware reset switch. None required.
READER_RESET_FP
_SWITCH_SERIAL_
RAWMODE_SET_
ERROR event.warning.sw Error detected during reset of serial interface
raw mode to FALSE when pressing the hardware
reset switch. None required.
READER_RESET_FP
_SWITCH_SERIAL_
SET_ERROR event.warning.sw Error detected during reset of serial interface
parameters when pressing the hardware reset
switch. None required.
SPARSE_ARRAY_
NULL event.warning.sw Indicates a non-existent sparse array. None required.
SYMBOL_TABLE_
DEFAULT_INVALID event.warning.sw Default value is invalid for the symbol. None required.
SYMBOL_TABLE_
FAILED_TO_
RESTORE event.warning.
configuration Indicates a failure in restoring the
configurations. None required.
SYMBOL_TABLE_
FAILED_TO_SAVE event.warning.
configuration Indicates a failure to save the configurations. None required.