Pag. 27
DUALNET—6 INSTRUCTION MANUAL
ENGLISH
18. Panel Functions:
With the control panel Disarmed, it is possible to Arm by pressing the correct number on the keypad
or wireless with a coded PEG-3 transmitter that has been learned by the control panel
To arm the panel in DAY mode with keypad:
The installation will arm with programmed exit time and check the zones with option
“Ready to Arm” on “Yes”
To arm the panel in NIGHT mode with keypad:
The installation will arm with the programmed exit time and check the zones with the
option “Ready to Arm” on “Yes”
To Disarm the panel with keypad:
If you wish to ARM the panel in
Day mode without an exit delay time
(immediate) in Day mode and
without taking into consideration if a zone is triggered. Digit on keypad the following:
If you wish to ARM the panel in
Night mode without any exit delay time
and without taking into
consideration if a zone is triggered. Digit on keypad the following:
The
zones that are triggered when the panel is being armed will be automatically by-passed
and will become active again if normalized. (see note no page 8)
Keypad service buttons
The keypad service buttons, seen below, must be pressed for 2 seconds to trigger an alarm.
3
4
5
6
7
8
9
0
#
1
2
T
E
2014 03 10
10 : 30 AM MON
Led lights during
transmission
Button 3
EMERGENCY CALL or
Hold-up alert.
With Button 1 you may
Arm and Disarm the
panel in DAY mode
With button 2, you
may Arm & Disarm the
control panel in
NIGHT mode
PEG-3
Pa 1
Pa 3
Pa 4
Pa 7
HOLD-UP FIRE
EMERGENCY
Pa 2
