15
14
3DISON H700
User Manual V.1
3DISON H700
User Manual V.1
D. Getting started:
Filament Loading and Leveling the Printing Bed
D2. Leveling the Printing Bed
Leveling before 3D printing is so crucial that it can influence the quality of the print-out. If the
printing bed is too far from the extruder’s nozzles, or if one part of the bed is farther away from the
nozzles than another part, your 3D prints might not stick to the bed.
Meanwhile, if the printing bed is too close to the extruder’s nozzles, the bed can block the filament
from extruding from the nozzles. This can also scratch the printing bed and tear the PET tape on it.
When using Standard Leveling (manually adjusting)
2. Select
Utilities > Standard Leveling
on the
display menu.
3. Level the printing bed by adjusting the round
knobs each time when the extruder reaches to
the front, rear, left, right and center in sequence.
(Press the OK button so that the extruder move to
another point.)
NOTE:
●
At this time, it is important that you should turn
the round knobs as same degree as possible at
the same time using both hands.
●
If knobs are turned to the
left
, the gap between
the nozzle and the printing bed will
increase
. If
knobs are turned to the
right
,
the gap between
the nozzle and the printing bed will
decrease
.
4. Upon completion of adjusting the round knobs each time when the nozzle reaches to
the printing bed in sequence, pull forward the A4 size paper and if the A4 size paper touches
the nozzle and slides with feeling of a little bit scratching, leveling has been completed.
Press OK button to finish the leveling.
NOTE: In CreatorK, uncheck the mark in the Auto-leveling item when generating Gcode.
1. Press the power button to start to adjust the
horizontality of the printing bed. Open the front
door and put a sheet of A4 paper onto the printing
bed before manual leveling.
NOTE: The thickness of A4 size paper is about
0.1mm and this paper is used in leveling the bed
to keep 0.1mm space between the nozzle and
the printing bed.
D2. Leveling the Printing Bed (Continued)
When using Auto-Leveling
D. Getting started:
Filament Loading and Leveling the Printing Bed
1. Place the A4 size paper first before using
Auto-leveling functions. Select
Utilities > Auto-
Leveling
in the display menu.
NOTE: The thickness of A4 size paper is about
0.1mm and this paper is used in leveling the bed
to keep 0.1mm space between the nozzle and
the printing bed.
3. Insert the SD Card on the top of the printer and
select the file on LCD panel. It starts to print with
auto leveling function.
NOTE: In CreatorK, check the mark in the
Auto-leveling item when generating Gcode.
2. When the extruder comes to the center, adjust
4 round knobs while trying to pull forward the A4
paper to verify the space as the same manner as
Standard Leveling (See item 4 in page 14).
NOTE:
●
In case of using Auto-Leveling, it is okay to level
the center of the printing bed only before use
unlike Standard Leveling.
●
It is recommendable to use Standard Leveling
one time in 10 times of Auto-leveling, or when
physical shock occurs to the printing bed.
