Page
8
of
44
3DGence Material Management System | version 1 | 03.2022
•
use only earthed power sources (to avoid electric shocks),
•
ensure sufficient free space around the device so that the door can always be fully opened,
•
when disconnecting the plug from the power supply, hold it by its cover, not by the cable,
•
disconnect the power supply before carrying out any repairs or maintenance,
•
ensure that the mains voltage and connection parameters comply with the specifications of the device,
•
protect the cable and power plug against damage,
•
disconnect the power plug before moving the device,
•
if the device is not used for a longer period of time, unplug the power plug,
•
observe the maintenance instructions,
•
always wear protective gloves when working with the MMS,
•
provide easy access to the emergency switch in the event of device failure,
•
If damage is evident, switch off the device and secure it against restarting.
1.3.
Symbols used in the 3DGence Material Management System device
3DGence is committed to making its devices safe and reliable. The device contains a number of warning stickers about the
potential hazards.
Warning of electrical voltage
. The symbol means that there is high voltage in the device and special care must be taken
in the areas marked with the symbol.
Warning of hot surface.
The symbol informs about the occurrence of high temperature in the area. Always take extra
care when handling heated parts and wear the protective gloves. Failure to observe the safety precautions may result
in serious burns.
Warning of crushing hands.
The symbol indicates that there is a hazard that could cause your hands to be crushed.
Warning of existing moving machine parts.
This symbol indicates that there is a hazard which may cause an accident
due to contact with moving parts of the device.
Gloves.
The glove symbol means that the protective gloves supplied must be worn when working in the area marked
with the symbol.
1.4.
Potential areas of security hazards
Some areas in the MMS pose potential safety hazards. Special care should be taken when using and maintaining the
device.
In the event of a fault, switch off the device using the main power switch at the back of the device. If there are
casualties as a result of the accident, then first aid should be provided. Please report failures to 3DGence Technical
Support. The device should also be protected against unauthorised start-up until the failure has been rectified.
•
Always wear protective gloves when working inside the working chamber. There may be a high temperature in the
chamber.
•
Do not wear loose clothing, ties or dangling jewellery when working near moving parts of the device.
•
Handle desiccant cartridges with care - do not shake them as dusting of the cartridge may occur.
•
Pouring liquids over or immersing the desiccant cartridge in liquids is prohibited due to its reactivity in water.
1.5.
Moving the device
For the user's safety and to avoid accidental damage to the device, the following rules must be observed when changing
its location:
•
before moving the device, switch it off and disconnect all connections,
•
the device should be cooled down and the consumables and all loose parts and accessories should be removed from all
chambers,
•
unlock the swivel castors before moving the device.
