Page
4
of
44
3DGence Material Management System | version 1 | 03.2022
I PREFACE
1.
INTRODUCTION
Thank you for choosing the 3DGence Material Management System device [MMS]. The following manual will guide you through
the correct preparation of materials for the printing process, guaranteeing the highest quality of printed items and allowing
for repetitive and safe operation of the device over a long period of time.
This manual contains the information necessary for the correct and safe use of the device. Before starting to work, it is
necessary to carefully read the entire contents of the manual below.
The MMS must not be used by anyone who has not read the manual. Improper use may damage the device, cause injury or
even endanger the life of the operator.
By starting to use the 3DGence Material Management System device, you are agreeing with the full content of the user manual,
you are agreeing with the guidelines contained therein and the warranty conditions available on the manufacturer's website:
www.3dgence.com.
Caution must be exercised when using the device due to residual risks that exist despite the inherent safety design,
safety measures and additional protective measures. Attention must be paid to markings and messages informing
about hazards, i.e. stickers on mechanical parts of the device, messages on the LCD display and warning sound signals.
Their meaning is described in this manual.
2.
TECHNICAL SPECIFICATIONS OF THE DEVICE
The 3DGence Material Management System is an industrial device designed to:
•
Store reels of printing materials.
•
Carry out the process of preparing spools of material for printing.
•
Carry out the recrystallisation process of printed components.
The device uses a hybrid system of hot air and industrial desiccant. The drying and recrystallisation parameters for the printed
elements, developed by the 3DGence team, were prepared based on industry standards for acceptable wet weight content in
the material. The technical specification of the device is shown in table 1.
Table 1 Technical specifications of the 3DGence Material Management System
DIMENSIONS AND WEIGHT
Device dimensions
(W x D x H)
- 1 chamber: 850 mm x 630 mm x 1740 mm
- 3 chambers: 850 mm x 630 mm x 1740 mm
- 6 chambers: 1560 mm x 630 mm x 1740 mm
Max. device dimensions with door open
(W x D x H)
- 1 chamber: 850 mm x 1090 mm x 1740 mm
- 3 chambers: 850 mm x 1090 mm x 1740 mm
- 6 chambers: 1560 mm x 1090 mm x 1740 mm
Device packaging (W x D x H)
TBD
Weight of the device without packaging
TBD
Weight of the device with packaging
TBD
ENVIRONMENT
Operating temperature
10
–
28°C
relative humidity between 30% and 60% without condensation
Storage temperature
-20
–
54°C
relative humidity between 10% and 85% without condensation
POWER SUPPLY
Required connection in European conditions
- 1 chamber: Plug 1ph 16A CEE 7/7
- 3 chambers: Plug 1ph 16A CEE 7/7
- 6 chambers: Plug 3ph 32A CEE 17
Required connection in US conditions
- 1 chamber: Plug NEMA L6 20A
