3D Systems projet mjp 2500, User Manual, Page: 7 / 92

Packaging Inspection
The material cartridges are packaged in shipping cartons. Upon receipt of material shipments, inspect cardboard carton exterior for signs of damage and
leakage. If leakage is observed, DO NOT open carton, and contact 3D Systems’s Technical Support Hotline.
VisiJet® Part Material VisiJet® ME SUP Wax Support Material
Shelf Life 2 Years 5 Years
Climate Cool, dry area with adequate ventilation
Temperature Range 60°F (16°C) to 80°F (27°C)
Maximum Storage Temp 95°F (35°C)
Environmental Conditions
No direct sunlight, heat, flames, or UV energy. Do not expose materials to heat at or above 230°F (110°C) , flames, sparks, or any
source of ignition.
Storing a Partially Used Material Cartridge
It is important not to lay material cartridges that are partially used on their side. Doing so will cause material to seep through the vent cap and clog cap. This will
cause damage to the material cartridge if used for a later print. To store a partially used Material Cartridge, place it upright in a ProJet 2500 Cartridge Holder and
tighten the vent cap.
Recertification Date
Always check material "Recertification Date" before use. Do not load material cartridges into the ProJet MJP 2500 or 2500 Plus if the cartridge date has expired.
When an expired cartridge is inserted, the printer will reject it. If a job is printing when the cartridge expires, it will to continue to complete the job before
declaring the cartridge is no longer available for use. 3D Systems certified Partners or 3D Systems Technical Support can assist with questions on materials
required recertification.