3Com V3000 ANALOG, Installation Manual

Page: 28 / 252

28 C
HAPTER
1: I
NTRODUCTION
Table 7 V3001R System Status LEDs - S1 and S2
4 Console DB-9 connector that provides an RS-232 (DCE) TTY terminal
connection for access to system CLI commands and status
messages. For more information, see
“Connecting a Computer to
a Console Port” on page 196 .
5 Status
Lights S1 and S2 provide a visual indication of system status. See
Table 7 , for flash pattern information.
6 Ext. Alert Reserved for future use.
7 Paging RJ-11 connector for a 600 Ohm analog paging amplifier.
8 MOH Mini-jack (3.5 mm, mono or stereo) that accepts Music-On-Hold
audio (maximum 2V peak to peak) from the line output of a CD
player, tape player, or other music source.
9 Ethernet 10/100 switched Ethernet connection redundant uplink ports.
Use either Ethernet port to connect to the LAN. If the other port is
connected, it becomes active only when the active port
experiences a link failure. The ports stay in that state even after
the failed port returns to a positive link state. Both ports show a
positive link status even though only one port at a time is active.
Typically, you would connect each port to a different switch and
subnet.
LNK/SPEED:
■
Yellow — 10Mbit link
■
Green — 100Mbit link
■
Off — No link
ACT:
■
Flashing Green — Activity on port
■
Off — No activity
Explanation S1 S2
Attempting to boot from disk 1 (zero) Off Flashing
Attempting to boot from disk 2 Flashing Off
Flash codes for disk problems:
■
2 flashes : No valid disk (system is halted).
■
3 flashes : Two valid disks, but they are not paired (system is
halted).
■
4 flashes : Configuration problem (system is halted).
■
5 flashes : Two disks present, but no mirroring license
installed. System is running but the system is not using the
second disk.
Unison flashing
Table 6 V3001R Connectors and LEDs (continued)