Using the Diagnostic Program
6-5
To run the tests continuously, select the
Continuous
option
in the Test Setup dialog box, as described in the next
section, “Changing the DOS Test Setup.”
Changing the DOS Test Setup
To change the test parameters, follow these steps:
1 Select
Test Setup
in the Run Tests dialog box and
press Enter.
The Test Setup dialog box appears, as shown in Figure 6-4.
Figure 6-4
DOS Diagnostic Program Test Setup Dialog Box
2 Press Tab to move from field to field and select any
field within the Test Setup dialog box.
Within the Group Select area, use the arrow keys to select
Group 1. (Future software enhancements will provide
additional test groups.) Use the
Enable Group
or
Disable
Group
options to enable or disable a group of tests.
For test descriptions, see “DOS Diagnostic Tests” earlier
in this chapter.
3 Select
OK
and press Enter.
4 To run the tests, select
Run Tests
from the
Test
menu
and select
Start
.
Book Page 5 Saturday, November 1, 1997 3:13 PM
