3-4
C
HAPTER
3: N
OVELL
N
ET
W
ARE
E
NVIRONMENTS
AutoLink Troubleshooting
If you experience problems when using the AutoLink
program, display or print the AUTOLINK.LOG file, which
contains a log of the events that occurred during the
AutoLink installation and configuration process.
1 To display the file, enter the following DOS
command:
type autolink.log | more
2 To print the file, connect to a local printer and enter:
copy autolink.log prn
or
print autolink.log
Installing a DOS 16-Bit Client Manually
If you did not use the AutoLink configuration utility, follow
these steps to install the DOS 16-bit client driver for NetWare:
1 Insert the
Novell NetWare Client for DOS and
Microsoft Windows Disk
1 and make that drive the
active drive. For example, enter:
a:
2 Enter the following command:
install
Follow the displayed instructions as they appear.
3 When prompted to select the driver for your network
board, scroll down through the list titled
Network
Boards
. Select
Other Drivers
, and press Enter.
4 If you are using the 3.5-inch
TokenDisk
diskettes,
insert
TokenDisk
diskette #1 in the drive and make
that drive the active drive. For example, enter:
a:
If you are using the
TokenDisk
CD, insert it in the
CD-ROM drive and enter the location of the DOS
16-bit client driver:
<drive>\netware\nwclient
5 Select
3Com TokenLink Velocity XL PCI
and press Enter.
The program copies all relevant files and makes required
changes to the AUTOEXEC.BAT and CONFIG.SYS files.
Book Page 4 Saturday, November 1, 1997 3:13 PM
