3Com MSR 50 Series, Configuration Manual

Page: 755 / 2443

Telnet Terminal Access Configuration 755
3
Add a route on the FEP.
# route add 2.2.2.1 -netmask 255.255.0.0 1.1.247.88
Telnet Terminal Access
Configuration
Configuring the Telnet Initiator
Follow these steps to perform basic Telnet initiator configuration:
n
■
For details about the async mode flow command, refer to the async mode
command in “WAN Interface Configuration” on page 99 .
■
After a template is applied on an interface, you need to set the flow control
mode of the user interface corresponding to the interface to software flow
control. You can use the
display user-interface command to display the
associations between interfaces and user interfaces.
■
For details about the user-interface command, refer to the user-interface
command in “User Interface Configuration” on page 2155 .
To do... Use the command... Remarks
Enter system view system-view -
Enable terminal access
on the router rta server enable Required
Disabled by default
Create a terminal
template and enter
terminal template view rta template template-name Required
Configure a Telnet VTY vty vty-number telnet remote
ip-address [ port-number ] [ source
source-ip ]
Required
After this configuration, the
template can be configured
with Telnet VTYs, but not RTC
client VTYs or RTC server VTYs.
Exit terminal template
view quit -
Enter interface view interface interface-type
interface-number
Required
The interface type must be
supported by terminal access.
Configure the
asynchronous serial
interface to operate in
the flow mode async mode flow Required
By default, an asynchronous
serial interface operates in the
protocol mode and an AUX
interface the flow mode.
Apply the template to
an interface rta terminal template-name
terminal-number
Required
Exit interface view. quit -
Enter TTY user
interface view user-interface { first-num1
[ last-num1 ] | tty first-num2
[ last-num2 ] }
-
Enable software flow
control of data on the
current user interface flow-control software Required
By default, the flow control
mode is
none ; that is, no flow
control is implemented.