3Com MSR 50 Series, Configuration Manual

Page: 2434 / 2443

2434 C
HAPTER
140: C
ALL
S
ERVICES
C
ONFIGURATION
Enabling Hunt Group Follow these steps to enable hunt group:
Configuring Hunt Group
Priority Level
Follow these steps to configure a hunt group priority level:
n
■
Currently, a priority level applies to only the features of call waiting, call
forwarding, and hunt group.
■
By default, the priority levels for hunt group, call forwarding, and calling
waiting are 1, 2, and 3 respectively. The smaller the value is, the higher the
priority level is. When you change the priority level of a feature, make sure that
different features have different priority levels.
■
You must configure the hunt-group enable command on all FXS voice
subscriber lines if you want to use the hunt group feature.
Configuration Example Telephone B and Telephone C have the same number, but Telephone B has a
higher priority than Telephone C (the POTS entity priority of Telephone B is
configured in POTS voice view using the
priority command). Telephone A calls
Telephone B and Telephone B is busy. In this case, the hunt group service enables
Telephone C to have a conversation with Telephone A.
# Enter voice subscriber line view.
<Sysname>system-view
[Sysname]voice-setup
[Sysname-voice]subscriber-line 2/0
# Enable hunt group.
[Sysname-voice-line2/0] hunt-group enable
Configuring Incoming
Call Barring
When you do not want to receive any incoming call, you can enable incoming call
barring (namely, the Do Not Disturb feature)
The device supports two incoming call barring configuration methods:
To do... Use the command... Remarks
Enter system view system-view -
Enter voice view voice-setup -
Enter voice subscriber line
view subscriber-line line-number -
Enable hunt group for the
voice subscriber line hunt-group enable Required
Disabled by default.
To do... Use the command... Remarks
Enter system view system-view -
Enter voice view voice-setup -
Enter voice subscriber line
view subscriber-line line-number -
Configure a priority level for
hunt group hunt-group priority level Optional
1 by default.