3Com EtherLink 10, User Manual

Page: 80 / 90

80 A
PPENDIX
F: D
YNAMIC
A
CCESS
T
ECHNOLOGY
The minimum client requirements and recommended Microsoft Service Packs (if
any) for Dynamic
Access technology are listed in the following table.
Installing
DynamicAccess
Technology
Dynamic Access technology is copied to your hard drive, but not installed, when
you install the NIC software.
To install Dynamic Access technology:
1 Make sure that the NIC and the NIC software are installed on your PC.
To confirm the NIC installation
Go to: Verifying Successful Installation .
2 Start Windows.
3 Insert the EtherCD in the CD-ROM drive.
4 When the EtherCD Welcome screen appears, select NIC Software ,
DynamicAccess ® Technology , and then Install DynamicAccess ® LAN Agent
Version 2.0 now .
Dynamic Access technology is installed. To verify that the installation was successful
Go to: Verifying Successful Installation .
Operating
System
PC Requirements
Recommended Microsoft
Service Pack
Windows 2000 486/76 MHz CPU
16 MB RAM (32 MB recommended)
5 MB available hard drive space
None required
Windows 95 486/76 MHz CPU
16 MB RAM (32 MB recommended)
5 MB available hard drive space
Windows 95 OSR2 or Service
Pack 1
Windows 98 486/76 MHz CPU
16 MB RAM (32 MB recommended)
5 MB available hard drive space
Service Pack 1
Windows NT 4.0 Pentium/100 MHz CPU
32 MB RAM
5 MB available hard drive space
Service Pack 4
Windows NT 3.51 Pentium/100 MHz CPU
32 MB RAM
5 MB available hard drive space
Service Pack 5
CAUTION: If you have a multiprocessor PC that is running Windows NT 4.0,
Service Pack 4, download and install the appropriate Microsoft patch before
beginning the installation. Failure to install the patch will result in system failure.
To download this patch. To download this patch
Go to: http://www.3com.com/dynamicaccess/hotfixes .