3Com 3CR990, User Manual

Page: 28 / 90

28 C
HAPTER
4: W
INDOWS
D
RIVERS
10 Select the CD-ROM drives option, clear any other checked options, and
click Next .
The Driver Files Search Results screen appears.
Windows finds the driver on the CD.
11 Click Next .
Files are copied, and then the message “Windows has finished installing the
software for this device” appears.
12 Click Finish .
The software installation is complete. To verify that the installation was successful
Go to: Verifying Successful Installation .
To change configuration settings
Go to: 3Com DOS Configuration Program .
Windows 98
This section describes how to install the network driver and NIC software in a PC
or server running Windows 98.
Before installing the NIC software:
■
Make sure that the NIC is installed in the PC and connected to the network.
■
Make sure that you have the Windows 98 installation files. These files may be
on a CD or diskettes, or they may have been copied to your hard disk when
Windows 98 was installed on your PC.
To install the software:
1 Turn the PC power on.
Windows detects the NIC. The Add New Hardware Wizard starts.
2 Click Next .
The Add New Hardware Wizard screen prompts you to select an option.
3 Select the Search for the best driver for your device (Recommended) option,
and then click Next .
The Add New Hardware Wizard screen prompts you for the driver location.
4 Select the CD-ROM drive option and clear any other check options that
are selected.
5 Insert the EtherCD in the CD-ROM drive, and then click Next .
Windows finds the driver file for the device.
6 Click Next .
Files are copied.
The Insert Disk screen appears, prompting you for the Windows 98 CD-ROM.
NOTE: If you encounter problems during the installation, see TROUBLE.TXT
(located in the HELP directory on the EtherCD ) for troubleshooting tips.