3Com 3C421600A, Management Manual

Page: 209 / 300

Basic Frame Relay Configuration Using the Command Line Interface
207
3 Specify additional network parameters for the user.
a If you are configuring an unnumbered interface, use the following
command:
set network user <username> remote_ip_address
<xxx.xxx.xxx.xxx/x>
The remote_ip_address for an unnumbered link may be the IP address
of the remote router Ethernet port, depending on the configuration of
the remote router.
b If you are configuring a numbered interface, use the following
command:
set network user <username> remote_ip_address
<xxx.xxx.xxx.xxx/x>
set dial_out user <username> local_ip_address
<xxx.xxx.xxx.xxx>
The remote_ip_address for a numbered link is the IP address of the
remote router WAN port. The local_ip_address is the IP address of the
local router WAN port.
4 Set the user routing options as follows. For a command description see
Table 54.
set network user <username> ip_routing [both | send | listen
| none] rip [ripv1 | ripv2]
5 For IPX, specify the network address, WAN status, routing options, and
spoofing status.
set network user <username> ipx_address <ipx net address>
ipx_wan [enable | disable] ipx_routing [all | listen | none |
respond | send] spoofing [enable | disable]
6 For IPX, specify an internal IPX system number to support IPX_WAN.
set ipx system number <number> name <system name>
Table 54 IP Routing Levels
Command RAS 1500
Listen Listens to RIP updates from the user and updates the local routing
table
Send Sends RIP updates to the user
Both Listens to and send RIP updates
None Does not listen to nor send RIP updates