3Com 3C421600A, Management Manual

Page: 199 / 300

RADIUS Accounting
197
4 Determine whether accounting information is sent to the primary server
only (the secondary server acts as a backup) or whether accounting
information is sent to both the primary and secondary servers until a
response is received from both servers. Use the following command:
set accounting use_servers [ONE | BOTH]
5 Set the number of retransmissions. This is the total number of times the
RAS 1500 retransmits an authentication request to both the primary and
secondary RADIUS servers. Use the following command:
set accounting retransmissions <count>
6 Set the time at which the RAS 1500 begins accounting, either at the
point of authentication or the point of connection. Use the following
command:
set accounting start_time [authentication | connection]
7 Set the interval (in seconds) between retransmissions. Use the following
command:
set accounting timeout <number_seconds>
8 Set the UDP port to match the UDP port setting on the RADIUS server.
The default is 1646. Use the following command:
set accounting primary_port <port_number>
set accounting secondary_port <port_number>
The following example configures accounting and saves the changes.
(Two separate commands are shown.)
set accounting primary_server 2.2.2.2 secondary_server
2.2.2.3 primary_secret bishop secondary_secret cardinal
use_servers both retransmissions 3 start_time connection
timeout 60 primary_port 4444 secondary_port 4445
save all