ZyXEL Communications Prestige 128IMH, Руководство пользователя, Страница: 52 / 142

ZyXEL Prestige 128IMH User’s Guide
Page 6-4
¿ ù » ~
!
© |¥ ¼ © w ¸ q¼ Ë ¦ ¡ ¡ C
Authentication Protocol).
Ougoing: Pri/Sec
Phone Number Both the Primary Phone number and the Secondary Phone number
refer to the number that the Prestige will dial to connect to the
remote node. The Prestige always calls the remote node using the
Primary Phone number first. If the Primary Phone number is busy or
does not answer, the Prestige will call the Secondary Phone number
if available.
Route This field determines the protocols that the Prestige routes. The
features enabled on your Prestige determine the choices for this
field.
Bridge Bridging is used for protocols that are not supported or not turned on
in the previous route field e.g., SNA. When bridging is enabled, the
Prestige will forward any packet that it does not recognize to this
remote node; otherwise, the unrecognized packets are discarded.
The disadvantage of bridging is that it usually generates large
amounts of traffic. Press the space bar to select either Yes or No.
Edit PPP Options
Yes brings you to Menu 11.2 - Remote Node PPP Options (see
below).
Rem IP Addr
This is a required field if Route is set to IP. Enter the IP address of
this remote node.
Edit IP/IPX/Bridge
Options
Yes brings you to Menu 11.3 - Remote Node Network Layer
Options. For more information on filling out this screen, refer to the
chapter pertaining to your specific protocol
Telco Options:
Transfer Type This field controls the type of connection between your Prestige and
the remote node. There are four choices for this field: 64K,
Modem ,Leased or Nailed-up Connection.
Telco Options:
Period (hr) This field sets the time interval to reset the above outgoing call
budget control.
Session Option: Edit
Filter Sets Select Yes to show the screen below.
Session Option: Idle
Timeout (sec) This value specifies the number of idle seconds that elapses before
the remote node is automatically disconnected when the Prestige is
calling back. Idle seconds is the period when there is no data passed
from the Prestige to this remote node. Administrative packets such
as RIP are not counted as data. The default is 300 seconds (5
minutes).
Table 6-1 Menu 11.1 - Remote Node Profile Fields
Selecting Yes to the Session Option: Edit Filter Sets field displays the screen below.
These fields allow you to specify which filter set(s) you wish to implement to filter the
incoming and outgoing traffic between this remote node and the Prestige. You can choose
from 12 different filter sets. In addition, you can link up to 4 filter sets together for further
customization (e.g., 1, 5, 9, 12). Note that spaces and commas are accepted in this field.