PM7300-T0 User’s Guide
44
C
HAPTER
12
Remote Management
12.1 Overview
Remote management controls which services can access the PM7300-T0 in the interfaces you select.
12.2 The Remote Management Screen
Use this screen to configure which services can access the PM7300-T0 and which interfaces can allow
them. You can also specify the port numbers the services must use to connect to the PM7300-T0. Click
Maintenance > Remote Management
to open the following screen.
Figure 30
Maintenance > Remote Management
The following table describes the fields on this screen.
Table 23 Maintenance > Remote Management
LABEL
DESCRIPTION
Service
This is the service you may use to access the PM7300-T0.
LAN
Select the
Enable
check box for the corresponding services that you want to allow access to the
PM7300-T0 from the LAN.
WAN
Select the
Enable
check box for the corresponding services that you want to allow access to the
PM7300-T0 from the WAN.
Port
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Apply
Click
Apply
to save your changes back to the PM7300-T0.
Cancel
Click
Cancel
to restore your previously saved settings.
