ZyXEL Communications MES3500 Series, Руководство пользователя

Страница: 148 / 370

Chapter 17 Link Aggregation
MES3500 Series User’s Guide
148
Figure 76
Advanced Application > Link Aggregation > Link Aggregation Setting
The following table describes the labels in this screen.
Table 49
Advanced Application > Link Aggregation > Link Aggregation Setting
LABEL DESCRIPTION
Link
Aggregation
Setting This is the only screen you need to configure to enable static link aggregation.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple
ports.
Active Select this option to activate a trunk group.
Criteria Select the outgoing traffic distribution type. Packets from the same source and/or to the same
destination are sent over the same link within the trunk. By default, the Switch uses the
src-
dst-mac distribution type. If the Switch is behind a router, the packet’s destination or source
MAC address will be changed. In this case, set the Switch to distribute traffic based on its IP
address to make sure port trunking can work properly.
Select src-mac to distribute traffic based on the packet’s source MAC address.
Select dst-mac to distribute traffic based on the packet’s destination MAC address.
Select src-dst-mac to distribute traffic based on a combination of the packet’s source and
destination MAC addresses.
Select src-ip to distribute traffic based on the packet’s source IP address.
Select dst-ip to distribute traffic based on the packet’s destination IP address.
Select src-dst-ip to distribute traffic based on a combination of the packet’s source and
destination IP addresses.