ZyXEL Communications MES3500-24, Руководство пользователя

Страница: 82 / 349

Chapter 7 System Status and Port Statistics
MES3500-24/24F User’s Guide
82
The following table describes the labels in this screen.
Table 7
Status
LABEL DESCRIPTION
Port This identifies the Ethernet port. Click a port number to display the Port Details
screen (refer to
Figure 27 on page 83 ).
Name This is the name you assigned to this port in the Basic Setting > Port Setup
screen.
Link This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or
1000M for 1000Mbps) and the duplex (F for full duplex or H for half). It also
shows the cable type (Copper or Fiber) for the combo ports.
This field displays Down if the port is not connected to any device.
State If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the
port (see
Section 13.1 on page 122 for more information).
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it
displays STOP.
LACP This fields displays whether LACP (Link Aggregation Control Protocol) has been
enabled on the port.
TxPkts This field shows the number of transmitted frames on this port.
RxPkts This field shows the number of received frames on this port.
Errors This field shows the number of received errors on this port.
Tx KB/s This field shows the number of kilobytes per second transmitted on this port.
Rx KB/s This field shows the number of kilobytes per second received on this port.
Up Time This field shows the total amount of time in hours, minutes and seconds the port
has been up.
Clear Counter Enter a port number and then click Clear Counter to erase the recorded statistical
information for that port, or select Any to clear statistics for all ports.