ZyXEL Communications MES3500-24, Руководство пользователя

Страница: 266 / 349

Chapter 34 Static Route
MES3500-24/24F User’s Guide
266
34.2 Configuring Static Routing
Click IP Application > Static Routing in the navigation panel to display the screen as shown.
Figure 150
IP Application > Static Routing
The following table describes the related labels you use to create a static route.
Table 106
IP Application > Static Routing
LABEL DESCRIPTION
Active This field allows you to activate/deactivate this static route.
Name Enter a descriptive name (up to 10 printable ASCII characters) for identification
purposes.
Destination IP
Address This parameter specifies the IP network address of the final destination.
IP Subnet
Mask Enter the subnet mask for this destination. Routing is always based on network
number. If you need to specify a route to a single host, use a subnet mask of
255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
Gateway IP
Address Enter the IP address of the gateway. The gateway is an immediate neighbor of your
Switch that will forward the packet to the destination. The gateway must be a
router on the same segment as your Switch.
Metric The metric represents the “cost” of transmission for routing purposes. IP routing
uses hop count as the measurement of cost, with a minimum of 1 for directly
connected networks. Enter a number that approximates the cost for this link. The
number need not be precise, but it must be between 1 and 15. In practice, 2 or 3 is
usually a good number.
Add Click Add to insert a new static route to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to reset the above fields to your previous configuration.
Clear Click Clear to set the above fields back to the factory defaults.
Index This field displays the index number of the route. Click a number to edit the static
route entry.
Active This field displays Yes when the static route is activated and No when it is
deactivated.