ZyXEL Communications IES4005M, Руководство пользователя

Страница: 84 / 236

Chapter 11 Management
IES4005M User’s Guide
84
This table describes the commands.
Table 58
Alarm Commands Summary
COMMAND DESCRIPTION M P
show alarm current [severity <severity>] [alarm
< alarm >] [condition < condition >] [start-date
< month >/< day >/< year >] [end-date < month >/< day >/
< year >] [forward|reverse] [detail] [indexes]
Displays current alarms.
indexes
displays alarm indexes information
E 1
clear alarm current [condition < condition >
indexes < index1 >/< index2 >/< index3> ]
Clears all clearable current alarms or alarms
with the specified condition code and indexes
condition
: check for alarm definition table
for allowed condition
index1
: target alarm index1, check for
indexes of alarm current table
index2
: target alarm index2, check for
indexes of alarm current table
index3
: target alarm index3, check for
indexes of alarm current table
E 13
show alarm history [severity < severity >] [alarm
< alarm >] [condition < condition >] [start-date
< month >/< day >/< year >] [end-date < month >/< day >/
< year >] [forward|reverse] [detail]
Displays alarm history. E 1
clear alarm history [severity < severity >] |
[alarm < alarm >] | [condition < condition >]
Clears historical alarms with the specified
severity or specified alarm or specified
condition or all severities. E 13
alarm definition alarm < alarm > condition
< condition > severity < severity > [syslog-
facility < facility >] [target < target >]
[clearable]
Configures the specified alarm definition.
condition
: check the alarm definition table
for allowed conditions or condition codes
clearable: alarm is clearable
C 13
show alarm definition [alarm < alarm >] [condition
< condition >] [severity < severity >] [target
< target >]
Displays the alarm definition table. E 1
alarm cutoff
Issues an alarm cutoff to stop signaling an
alarm. E 13
show interface dsl < slot/portlist > alarm line-
control
Displays the time interval settings for
reporting alarms when you enable alarm line-
control on the specified DSL ports. E 1
show interface dsl < slot/portlist > alarm
notification-severity
Displays the minimum severity level to send
out alarm notifications (SNMP trap and
SYSLOG) on the specified DSL ports. E 1
interface dsl < slot/portlist >
Enters the sub-command mode for configuring
the specified DSL ports. C 13
exit
Leaves the DSL port configuration. C 13
alarm line-control
Has the IES report alarms for the ports at
regular intervals instead of immediately. C 13
no alarm line-control
Turns off interval-based reporting of alarms so
the IES reports alarms immediately. C 13
alarm line-control interval < interval >
Sets the time interval (10-600 seconds) the
IES uses for sending alarms about these
ports. This applies when you enable alarm
line-control on these ports. C 13